Get the DeWalt DCF860B
Check the DeWalt DCF860B on AmazonSeller check: when checked on Oct 16 this listing was sold by a third-party seller and shipped by Amazon. Check the seller and that it’s new before you order.
1/4" cordless impact drivers · Comparison
The short answer
Most torque? DeWalt
Shorter head and longer warranty? Milwaukee
Both are brushless 1/4 in hex impact drivers sold as bare tools, with near-identical top speeds (3,800 vs 3,900 rpm) and a mode for self-drilling or self-tapping screws. DeWalt lists more torque (2,500 vs 2,000 in-lbs). Milwaukee’s is shorter and carries a 5-year warranty. Comparing the 2953-20 with the DCF845B instead? See DeWalt DCF845 vs DCF860
Best for torque

Seller check: when checked on Oct 16 this listing was sold by a third-party seller and shipped by Amazon. Check the seller and that it’s new before you order.
Best for tight spots and warranty
Seller check: when checked on Oct 16 this listing was sold by a third-party seller and shipped by Amazon, and the page also references 2953-20-C and 2953-20-I variants. Make sure it says plain 2953-20 (tool only) before you order.
Before you buy: I compared the two bare tools (no battery or charger). Both Amazon listings were sold by a third-party seller when checked on Oct 16, 2026, so check the seller, the exact model number and that it’s new before you order.
As an Amazon Associate I earn from qualifying purchases.
This counts the rows below where one is clearly better. It’s a tally, not a rating.
DeWalt wins 3: torque, work light and tool tracking. Milwaukee wins 2: length and warranty. The rest are even. A green check means a gap of more than 5% or a feature only one has. Every figure comes from the makers, not Amazon.
| DeWalt DCF860B | Milwaukee 2953-20 | |
|---|---|---|
| Platform | 20V MAX XR, brushless | M18 FUEL, brushless |
| Max torque | 2,500 in-lbs | 2,000 in-lbs |
| Top speed | 0-3,800 rpm | 0-3,900 rpm |
| Drive modes | 3 speeds (1-2 tuned for self-drilling screws) | 4-mode DRIVE CONTROL with self-tapping mode |
| Chuck | 1/4 in quick-connect hex | 1/4 in hex quick change |
| Work light | 9 LEDs, 20-minute work light | Tri-LED |
| Tool length | 5.63 in | 4.47 in |
| Weight as listed | 2.8 lb assembled product weight | 2.2 lb without battery |
| Tool tracking | Tool Connect chip-ready chip sold separately | Not ONE-KEY enabled |
| Warranty | 3-yr limited, 1-yr free service, 90-day | 5-yr limited |
The DCF860B wins 3 rows to 2 and is the pick on the tally, mainly for its extra torque. It’s a close call: two of DeWalt’s wins are features (the work light and Tool Connect), while Milwaukee’s shorter head and 5-year warranty are solid wins. On raw specs alone, leaving out the work light and Tool Connect feature rows, the Milwaukee leads 2 to 1. In practice your batteries should decide. Stay with the platform you already own.
Seller check: when checked on Oct 16 this listing was sold by a third-party seller and shipped by Amazon. Check the seller and that it’s new before you order.
Seller check: when checked on Oct 16 this listing was sold by a third-party seller and shipped by Amazon, and the page also references 2953-20-C and 2953-20-I variants. Make sure it says plain 2953-20 (tool only) before you order.
As an Amazon Associate I earn from qualifying purchases.